Help / FAQ

Yes, we at Hoppa Street Buggy offer this service.

No, Hoppa Street Buggy would advise that a spaceframe is also needed for added stability. Some beach buggies did not find it necessary, however a body kit with thicker laminated shell and stiffened areas for people that may prefer this approach is offered.

Yes

No, the windscreen and rubber comes from a Fiat 126 air-cooled, most screen fitters can supply this.

Only the hinges for the bonnet and boot. They are from the original Mini doors and can be bought off the shelf from Mini aftermarket suppliers.

Hoppa Street Buggy can supply GRP panels that can be sprayed or covered. The design of the panels reflect the theme of the exterior.

Both hard roof and a soft folding top are currently under development.

It is entirely up to you, there is enough room in the boot for almost any engine.

It is your choice, just remember that if you increase or decrease the overall diameter of the tyre, it may affect your speedo reading also note number of studs and PCD but along with wheel offset, can be solved with the use of spacers.

That really good finishing touch would be our unique Centre Console which goes over the handbrake lever and gearshift lever and gives opportunity to fit extra dials or switches.

A basic Body Kit depends entirely upon your requirements, however the cost may depend on your own expertise, enthusiasm, friends and resources. It is a project that can be built on, changed, upgraded or ‘buy it as you build’ – totally your choice. Talk to us and we will try turning your dream into reality.

The Hoppa Street Buggy is a “Fun Car” based on the air-cooled VW Beetle.

All of the mechanicals and electrics, however once the body is removed the underfloor and tunnel needs to be shortened by 400mm.